Trilaminate Non-Magnetic Drysuit

Photographed with the Dry Glove System. Quickly and easily fitted to any drysuit for protection from chemical, biological and hydrocarbon contamination.

The Trilaminate Non-Magnetic Drysuit is an all-black, front entry membrane suit. Made from Cordura with a medium-duty waterproof BDM metal zipper, these suits have been designed primarily for working / engineer divers.

The Kevlar® anti-slip coating on the seat, knees and elbows is designed for improved grip and flexibility. These areas are reinforced to extend the lifetime of the suit and ensure that key high-usage areas don't wear out and need repair more quickly.

The Trilaminate non-magnetic suit has a zipped pocket at waist height on either side so you can easily carry your dive essentials. The zipped cargo pocket is, like the suit, made of Cordura. The zip is a YKK® sea-water resistant one that closes to the front for easy access and closing when you're diving or on land. The cord puller on the zip is made from webbing material. Fitted with a mesh drainage strip at the bottom of the pocket to avoid excess build up of water when opened underwater.

The reinforced seat and seam free crotch are lined with Kevlar for extra protection while the anti-slip coating improves flexibility. This front entry Cortex suit is also fitted with a protective zip flap held in place with a hook and loop fastening closure to avoid damage to the medium duty 8 pitch BDM metal zip. We recommend the zip flap is also kept closed when the suit is not in use.

The internal braces are elasticated, but also have Triglide buckles so that they can be easily adjusted to a comfortable size for the wearer. The crossover design gives added stability and ensures a good fit.

All reinforced Kevlar® areas are sewn, not glued, to ensure the bonding to the suit is stronger and more hard wearing. Where possible, these reinforced areas are also integrated into the seams for further durability.

The suit also comes fitted with a medium duty BDM metal fly zipper, it's covered with a Cortex zip cover with a hook and loop fastening closure.

All reinforced areas; knee pads, crotch and elbow pads have drain holes, as do the pockets. This is to ensure there's not an excessive build up of water and air. The drain holes are reinforced by an area of printing around them so you don't need to worry about tearing occurring from them.

Black wide tape Dacor safety boots are integrated into the suit. Made from vulcanised rubber over-cladding with a 6mm neoprene lining they're fully waterproof. 

A neoprene hood is included with the suit as a separate item. It's 6mm hood as standard, including lining. The face seal is skin / skin, all seams are glued and blind-stitched on outside only.